lkakcoffee.blogg.se - For ipod download Magic Cube Puzzle 3D

Yours can be different than mine but it's ok. Rotate the viewing cube to make sure you are doing fine.

It can be confusing to "see" where you are going.

Remember to reactivate it when you finish this step

To make it easier to select each point, you can change the cube component to be unselectable by right-clicking it and selecting "Selectable/Unselectable".

You should only pass through each point once.

Create your own solution by connecting different points with the line command.

This will allow you to make a line connecting points from the 3 planes we made.

Create a new sketch on the front plane and check the box of "3D Sketch" on the Sketch palette on the right.

You should end with something like picture #5 Repeat the same sketch on each one of the offset planes we created.

To make a point, you can find it on the Create dropdown menu.

Make a point in the center of each square (Picture #4) and finish the sketch.

It will be easier to select the plane if you go to the left side "browser tree" to find it The offset value should be 10mm, 30mm, and 50mm

Next, create 3 offset planes from the front plane so that they are just in the middle of each layer.

This will make the cubes look transparent.

Start by activating the top assembly and then create a new component, name it as "string".

In this step, we will let you create the template for the solution of the puzzle.